Ether start on a Cat 3116

Created On Friday 5, October, 2007 1:28 PM by mifirewoodguy

Please enter your login information to post.
Username:
Password:
I want to stay logged in.

Message Title:

Message Text:

http

https

ftp

mail

hr

highlight

LI Quote

[q]Is it ok to install an ether start on a cat 3116? It has a manifold heater but I dont think it has glow plugs. And if its possible where would I put the ether injection nozzel?[/q]

HTML code is not permitted. Special symbols permit some HTML functionality.

mifirewoodguy

Posts: 4
Joined: Aug 2007

Friday October 05, 2007 13:28
Is it ok to install an ether start on a cat 3116? It has a manifold heater but I dont think it has glow plugs. And if its possible where would I put the ether injection nozzel?

Quote

Top

Bottom

Snafoow

Posts: 79
Joined: Mar 2006

Friday October 05, 2007 17:10
No its not ok. The intake heater is capable of igniting ether when it is sprayed into the intake system.

Quote

Top

Bottom

31CATdr26b

Posts: 16
Joined: Nov 2007

Wednesday November 28, 2007 21:09

Do not install either into that engine. The Intake manifold will blow on you. You can remove the intake heater solenoid and hot wire for the solenoid but i do not recommend it. The intake heater should be enough to start this engine, if you are having problems with this engine getting started, it sounds to me you have another problem . 3116 are notorious for there injectors seating in the cyl head, if not seated correctly, or fuel adjustments off etc. It will cause a Hard start. I do not recommend either though it can be done .

Quote

Top

Bottom

tinkertanker

Posts: 8
Joined: Mar 2008

Wednesday March 19, 2008 09:36

Can be expensive AND dangerous. An Edsel I had in my youth (both of us always broke)
got the benefits of accumulated deposits in the intake manifold over several winter months.
You can figure out the rest, intake manifold AND hood 100 feet beside the road in the
snow 10 minutes after after pulling out of the driveway.

Which brings me to a supplementary question.

My Cat-426 has ether and of course it must be applied sparingly and only while the
engine is cranking good. Even then you can tell it's very close to knocking. The other
day I swapped out the cannister but the new one isn't working, the solenoid might not
be triggering it. So I got going with one of these newer Motomaster QuickStart
spray cans. The startup is MUCH smoother and I wonder if such might be available
in standard onboard cannister sizes. They contain ethyl ether, aliphatic acid and carbon
diaoxide. I know one mechanic uses just brake parts-cleaner.

I'm concerned about explosive deposits, do they come from ether or from other
addidives?

-------------------------
If DIY were a religion, hmmm... I just made it one.

Quote

Top

Bottom

[ CATEGORY LISTINGS : THREADS ]

Customer Testimonials

'I had a Cummins ISX600 sitting in my shop for 2 years and finally managed to sell it through DieselEngineTrader.com! Great service and I like the way that the Buyer was able to phone me directly.'

David G Bouchard, Los Angeles, USA

'Great program, real easy to list engines.'

Mike Howell, Eaglemark 4 Equipment, Ohio, USA

'We endorse and support your work. Because of your service I was able to sell my Cummins engine. I would gladly use Diesel Engine Trader.com in the future'

Jim Betts, Betts Boat Repair, Alaska USA

Ether start on a Cat 3116

Customer Testimonials

Newsletter