Replying to Thread:

Help! Water in oil, 6.354

Created On Friday 14, April, 2006 6:00 PM by DieselDon

Please enter your login information to post.
Username:
Password:
I want to stay logged in.

Message Title:

Message Text:

http

https

ftp

mail

hr

highlight

LI Quote

HTML code is permitted. Special symbols permit some HTML functionality.

DieselDon

Posts: 1
Joined: Apr 2006

Friday April 14, 2006 18:00

I have a Massey Ferguson 1135 with a Perkins AT6.354 Turbo. The machine belonged to a relative and hasn't been maintained very well over the years. I checked the oil and found it was an emulsified oil/water mix. Upon further investigation I also found oil in the coolant and when the engine is running there is visible "glugs" of air chugging out when the rad cap is removed. I figure I am looking at a head gasked or even worse a cracked block? Anyone out there with some trouble shooting suggestions? I have located a block for a 6.354 that was in a tractor but it was a non-turbo. Are all 6.354 blocks the same or is there a difference between a turbo/non-turbo engine?Any help would be appreciated. Thanks.

Quote

Top

Bottom

lobnerje

Posts: 2
Joined: Sep 2006

Sunday September 17, 2006 16:52

It sounds like you have exhaust entering your coolant. If for some reason the tractor should suddenly boil coolant out of the radiator overflow you can be assured this is happening. You can test the coolant for exhaust in the bubbles you are talking about. Diesel engine parts houses sell these litmus strips. I believe the exhast is coming through the seal on the piston liner. The piston liner could also have a small fracture where the exhaust comes through.

Determine which cylinder it is. You could re-torque the cylinder heads. If this does not work well tear the engine down.

Flash

Quote

Top

Bottom

Oldhousehugger

Posts: 2
Joined: Apr 2009

Friday April 03, 2009 16:01

Have you checked YT mag website for 1135 stories? Seems to me that the turbo has an oil line running to it which keeps it cool and lubricates the bearings. Perhaps the seal is gone in him allowing exhaust to enter oil. Water in the oil has been known to be caused by condensation in the engine or from getting caught in a flood where water gets down the dipstick. Look for the easy stuff first before you start pulling your hair out.
If the tractor has been sitting for a long time there may be corrosion between the back of the waterpump and the front of the head. Or it may be just the headgasket.

A word of advice about pulling the head on that tractor. You have to pull the battery box and loosen up the fasteners on the hydraulic lines which run forward to the big filter and the main pump as well as the oil cooler. I used wooden blocks to hold the lines up high enough to get the head loose. Either that or back out all the head studs and you don't even want to go there.

Worry last of all about a cracked block.

Quote

Top

Bottom

[ CATEGORY LISTINGS : THREADS ]

Customer Testimonials

'Greetings from Holland! I sold my Bedford 330 engine to a guy in Latvia, thank you for the good working of your website.'

Bas Mulder, Mulder Transport, Holland

'A guy in Australia was looking for an Isuzu engine and found ours advertised on DieselEngineTrader.com. We struck a deal and shipped the engine.'

Tom Schilling, Kelbe Bros Equipment Co, Wisconsin, USA

'We're getting calls almost every day as a result of our listings in DieselEngineTrader.com'

Steve Spencer, Midwest Diesel Inc, Michigan, USA

Help! Water in oil, 6.354

Customer Testimonials

Newsletter