CATEGORY LISTINGS > KUBOTA
Replying to Thread:

Engine Idle


Created On Thursday 1, November, 2007 11:40 AM by steinerguy

Please enter your login information to post.
Username:
Password:
I want to stay logged in.

Message Title:

Message Text:
bold italic underline
 http link
 https secure link
 ftp ftp link
 mail email link
   hr  
  highlight 
 LI   Quote  ordered list unordered list



HTML code is permitted. Special symbols permit some HTML functionality.

Diesel Talk Forum

steinerguy
Diesel Talk Forum
Posts: 4
Joined: Nov 2007

Note Thursday November 01, 2007 11:40 View thread in raw text format
Diesel Talk
I have a Steiner tractor with a 3 cylinder Kubota diesel. The engine was running full throttle when it idled to 1/4 throttle all at once. It runs smooth, but will not advance past 1/4 throttle. The linkage is fine and nothing appears out of adjustment. The oil level is normal and the filters appear normal as well. Any ideas?

Thanks.

Steiner Guy
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

Snafoow
Diesel Talk Forum
Posts: 79
Joined: Mar 2006

Note Thursday November 01, 2007 19:23 View thread in raw text format
Diesel Talk
Check Fuel supply pressure ?

Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

steinerguy
Diesel Talk Forum
Posts: 4
Joined: Nov 2007

Note Wednesday November 07, 2007 14:24 View thread in raw text format
Diesel Talk
I changed the fuel filters, but it did not make a difference. I don't have a means of checking the fuel pressure. Any other thoughts?

Steinerguy
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

Snafoow
Diesel Talk Forum
Posts: 79
Joined: Mar 2006

Note Thursday November 08, 2007 21:49 View thread in raw text format
Diesel Talk
Not familiar with the engine but I would make sure the fuel pump is making it to the full fuel position.

You should be able to disconnect the throttle linkage, at the throttle lever, which is on the fuel injection pump, and manually move the lever to full fuel position and see if the engine revs up.

It is also possible for this fuel pump lever to loosen and slip on the throttle shaft and give you reduced amount of throttle.

Is there any pto controls that limit engine speed on this tractor?
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

steinerguy
Diesel Talk Forum
Posts: 4
Joined: Nov 2007

Note Friday November 09, 2007 16:36 View thread in raw text format
Diesel Talk
The pump throttle linkage maxs at the factory throttle stop. I will remove the nut from the pivot linkage and see if it has slipped, as you suggested. I put a wrench to it at it was tight, but it still may have slipped.

Thanks

steiner guy
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

Snafoow
Diesel Talk Forum
Posts: 79
Joined: Mar 2006

Note Friday November 09, 2007 17:50 View thread in raw text format
Diesel Talk
Also, make sure the shutdown lever has its full travel and is reaching its full on position.
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

steinerguy
Diesel Talk Forum
Posts: 4
Joined: Nov 2007

Note Monday November 12, 2007 19:51 View thread in raw text format
Diesel Talk
I removed the lock nuts from the engine throttle shaft and the locater pin was positioned correctly on the throttle shaft. Next, I cut the safety wire from the factory stops and adjusted the set screws to max throttle position. The engine did rev higher, but still less than 1/2 throttle. Pressurizing the fuel tank made no difference in engine rpms. Neither did removing the air cleaner system.

No PTO on tractor. Fuel shut off is completely open.

I'm still perplexed.

Steiner Guy
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

stampsrobbo
Diesel Talk Forum
Posts: 3
Joined: Jan 2009

Note Thursday January 29, 2009 13:37 View thread in raw text format
Diesel Talk
don't know if you have your engine going yet, but it sound like the governor spring came unhook, if you remove your throttle control plate the spring will be under it

-------------------------
 Robie W Morris
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
Diesel Talk Forum

kyhamoge
Diesel Talk Forum
Posts: 2
Joined: Jan 2013

Note Friday January 11, 2013 10:21 View thread in raw text format
Diesel Talk
Hi Steiner Guy,

I came across this discussion and am very curious to know if you were able to resolve your problem with low idle?

I am experiencing the exact same problem with my Kubota diesel engine in my Bobcat skid steer.

Like you, I checked fuel lines, replaced filters, checked throttle linkage, etc. -- no luck confused

Upon the advice of others smarter than myself, I will attempt to check/replace governor springs.

Any feedback would be most helpful!

Thanks

-------------------------
 Daniel M. Brett
Diesel Talk Forum
Reply Diesel Talk Forum Quote Diesel Talk Top Diesel Talk Forum Bottom Diesel Talk
Diesel Talk Forum
  [ CATEGORY LISTINGS : THREADS ]




Duncan Rogers (Engineering) Ltd
Duncan Rogers (Engineering) Ltd
Big Bear Engine Company
Advertize on Diesel Engine Trader

Customer Testimonials

Newsletter

Subscribe to our mailing list to get all the latest DET news.as well as daily or weekly notifications of new engines, gensets and spare parts listings.

'Over 50% of my sales come through DieselEngineTrader.com - I really like the site, it's the best website for advertising my inventory.'

Jim Williams, Diesel Power Train Co., Colbert, WA, USA

'It took at least 4 weeks before we got our first inquiries for the 28 engines we listed - 3 months on we are making 3 to 4 sales per month! We're really pleased and I like the feature that shows how many views our engines get.'

Pete Melhuish, Northwest Diesel Parts, Portland, Oregon, USA

'We're thrilled with DieselEngineTrader.com! We sold an old CAT D343 within 1 month of listing and a Cummins engine within 3 months. We were amazed - we didn't think anyone would want them in the condition they were in!'

Stephanie Vaughan, Heavy Equipment Parts, Independence, USA

Copyright Diesel Engine Trader 2015